8
Installation
4
. After you have installed the upper and lower clamps, it’s time to address cable management. There are two cables
that connect to your PAR sensors coming from the EXO PAR adapter cylindar. Supplied with your EXO PAR system will
be several black, UV resistant Zip Ties. Fasten the sensor cables to the EXO PAR frame support arms as follows:
(3 locations)
NOTE
:
Dummy plugs are supplied for these cable’s connectors, plug these connectors when sensors are
removed or if only deploying 1 of your 2 PAR sensors. When not in use, the plugs can be stored in the
calibration cup extension.
Figure 8
Fasten the sensor cables to the EXO PAR frame support arms
3.
Once you have the EXO PAR system secured to the EXO2 sonde body it is time to deploy the sensor arms. To do
so simply lift the arms and install the pins where the two arms meet, as shown (figure 7).
Figure 7
Lift the arms and install the pins where the two arms meet
CAUTION:
Potential pinch hazard, be mindful of fingers.
