Xylem WTW SensoLyt 900, Руководство по эксплуатации

Страница: 5 / 12

SensoLyt
®
900(-P) Commissioning, measuring, calibration
5
ba75992s02 02/2017
2.2 Commissioning
Scope of delivery  ORP electrode SensoLyt
®
900(-P)
 Operating manual
Commissioning Prepare the electrode for measuring as follows:
 Remove the watering cap from the electrode tip. Possible salt deposits in
the area of the watering cap do not affect the measuring characteristics
and can easily be removed with deionized water.
 Connect the electrode to a free IDS sensor plug-in position of the multi
parameter probe or to an IDS connection of the meter.
To open and close the IDS plug-in position please note the Abschnitt 2.1
O
PENING AND CLOSING THE
IDS
PLUG CONNECTION
.

Calibrate the electrode according to the operating manual of the meter
and observe the rules in the following section while doing so:
Preparing the
sensor for
measurement
2.3 Calibration and measurement: General rules
 Avoid the carryover of any solution (sample or buffer solution) from one
Please keep the watering cap. It is required for the electrode to
be stored. Always keep the watering cap clean.
Connection cables in different lengths to connect the electrode to
the meter are listed in Abschnitt 7 W
EAR PARTS AND ACCESSORIES
.
SensoLyt
®
900 Connect the sensor to the meter.
The sensor is immediately ready to measure.
SensoLyt
®
900-P Connect the sensor to a free IDS sensor plug-in
position of the multi parameter probe or to an IDS
connection of the meter. To open and close the
IDS plug-in position please note the Abschnitt 2.1
O
PENING AND CLOSING THE
IDS
PLUG CONNECTION
.
The sensor is immediately ready to measure.
Connection cables in different lengths to connect
the SensoLyt
®
900-P sensor to the meter are listed
in Kapitel 7 W
EAR PARTS AND ACCESSORIES
.
Connect the sensor to the meter.
The sensor is immediately ready to measure.