Xylem LOWARA e-SV Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 33 / 48

en - Original instructions
e-SV series - Installation, Operation and Maintenance Manual 33
7 Troubleshooting
7.1 Precautions
WARNING:
Maintenance must be done by a technician possessing the technical-professional requirements
outlined in the current regulations.
WARNING:
Observe the safety requirements in the chapters on Use and Operation and Maintenance.
WARNING:
If a fault cannot be corrected or is not mentioned, contact Xylem or the Authorised Distributor.
7.2 The unit does not start
Cause Remedy
Power supply cut off Restore the power supply
The thermal overload protection of the motor
has been triggered Reset the thermal overload protection on the
control panel or the unit
The device that detects the absence of liquid or
minimum pressure has been triggered Top up the liquid or restore minimum pressure
Power supply cable is damaged Replace the power supply cable
The capacitor, if present, is faulty Replace the capacitor
Control panel faulty Check and repair or replace the control panel
Motor (coil) faulty Check and repair or replace the motor
7.3 The differential protection device (RCD) is activated
Cause Remedy
Motor leaking Check and repair or replace the motor
Unsuitable type of differential Check the type of differential