2
Warning
This document is not intended to replace the MIQ/IC2
module operation manual. Please use the operating
manual as a reference during the following functions;
installation, operation, cleaning, maintenance and
troubleshooting.
Step By Step Instructions
1
Install all cable glands to the bottom of the MIQ/IC2 module as shown below
2
Connect the cable to the terminal strip
1. Open the MIQ/IC2 module.
2. Open the cable gland fitting under the required input. Keep the blind plug fitting for later. modifications,
if necessary.
3. Loosen the coupling ring.
4. Feed the cable through the cable gland in the module housing.
5. Open the terminal strip with a small screw driver.
6. Connect the cable to the terminal strip with a small screw driver. Make sure to connect the first device to
“REC 1”.
7. Tighten the coupling ring to secure the cable in place.
8. Close the module.
