5
The schematic diagram shows the installation principle. Contact your engine
supplier for advice about the recommended connection points on your engine.
INDIRECT COOLED ENGINE
For maximum flow through the coil, the
inlet connection should be close to the
engine (A) and the discharge
connection should be close to the
circulation pump (D). Somewhat less
flow through the coil can be attained, if
required, by taking off hot water from a
point (B) downstream of (A) and
returning it to point (C) upstream of (D),
so that the pressure difference between
the coil take-off and return is a little less.
DIRECT COOLED ENGINE
Some direct-cooled engines provide for
a relatively high engine block
temperature. The recommended
connection points for the C-Warm
heating coil will vary according to the
engine design. Check your engine
manual and if necessary contact your
engine supplier for advice
ADAPTING THE ENGINE COOLING CIRCUIT
