Xycom 1510, Руководство пользователя, Страница: 8 / 41

1510 Industrial PC Computer System Manual
8
Optional Features
Processors
·
Socket 370 Celeron
Ò
433 MHz processor
·
Socket 370 Pentium
Ò
III 600 MHz processor
·
Socket 370 Pentium
Ò
III 700 MHz processor
SDRAM
·
32 MB SDRAM
·
64 MB SDRAM
·
128 MB SDRAM
·
256 MB SDRAM
Operating Systems
·
MS-DOS
Ò
(standard unless specified “no operating system”)
·
Windows
Ò
95
·
Windows
Ò
NT
Power On Management Configuration
The standard configuration for power management of the 1510 includes the use of a
momentary switch connected to CN2 on the backplane, allowing Wake On LAN control
of the system. If you require the ability to control the 1510 with a central power control,
you must reconfigure the 1510’s power supply. Disconnect the cable attached to CN2
(disabling the power switch on the front of the unit), located on the back plane near the
processor, then jumper PIN2 to PIN3 on CN2. The jumper is included in the kit shipped
with the 1510.
The following instructions describe the conversion of the 1510’s power control from the
use of the momentary switch with Wake On LAN control capability to that of central
power on/off control.
1. Unplug the power cord on the rear of the 1510.
2. Remove the side panel. With the front of the unit facing you, lay the 1510 on its right
side. Remove the eight screws that hold the left side panel in place (see figure 1-1).
3. Locate the CN2 connector on the backplane (see figure 1-2). Detach the connector
and let it rest inside the unit.
4. Jumper CN2 PIN 2 and CN2 PIN 3 together (see figure 1-2).
5. Reattach the side panel.
6. Apply the power cord to the rear of the 1510.