XVision X100 Series, Быстрое руководство

Страница: 20 / 44

20
X100 Series Quick Guide
INSTALL
&
CONNECT
SETUP
CONFIGURE
RECORDING
SOFTWARE
Resetting your camera
The Reset Button is used to restore the factory default settings. If you are experiencing problems
with the IP camera, sometimes restarting the device will make the system revert back to a normal state.
To reset, hold the button for at least 5 seconds. The camera will restore factory settings & reboot.
Auto Iris Lens
Remember to calibrate the Auto Iris lens once the camera has been set up and configured on the
network.
- See Appendix 1: HOW TO CALIBRATE AN AUTO IRIS LENS on page 41.
Note: Failure to calibrate the Auto Iris lens will result in the picture becoming dark over time.
Note: Restoring the factory default setting will lose all the previous settings including the IP address.
You will need to run the IPWizard II program to re-configure the camera to enable it to work properly again.
INSTALL
&
CONNECT