Voltage:
3.6V
Battery Capacity:
1.5Ah Li-Ion
Chuck Size:
6.35mm (Hex)
No Load Speed:
200/min
Max. Torque:
3Nm
Charge Time:
3-5hours
Tool Weight:
0.38kg
SPECIFICATIONS
OPERATION
4
CONTROLS
On/Off Trigger
1. Squeeze the On/Off Trigger to start the screwdriver.
2. To stop the screwdriver, release the On/Off Trigger.
Note:
This screwdriver does not have variable speed.
Note:
The On/Off Trigger can be locked by pushing the
Forward/Reverse Selector button into middle setting.
LED Worklight
1. Switch on the LED worklight by pressing the
Worklight Switch.
FIG. C
2. Press the switch again to turn the light off.
Forward Reverse Selector
1. For forward rotation, push the Forward/Reverse
Selector towards the left side of the tool.
FIG. D
2. For reverse rotation, push the Forward/Reverse
Selector towards the right side of the tool.
Rotating Handle
The ear handle of the screwdriver can be rotated
so that the tool can be operated in 2 different
configurations to assist with your job requirements.
The in-line orientation allows you to drive and remove
screws in hard to reach areas.
1. To operate the screwdriver in the in-line orientation,
press the Handle Lock Button (
FIG. E)
and then
rotate the Rear Handle.
FIG. F
2. To operate the screwdriver in the angled position,
press the Handle Lock Button and then rotate the
Rear Handle.
Driving and Removing Screws
1. Depress and release the On/Off Trigger to ensure it
is not locked.
2. Check the Forward/Reverse Selector is in the desired
setting.
3. Ensure the workpiece is secured to stop it turning
whilst driving.
4. Hold the tool firmly and then press the On/Off Trigger.
5. Once complete, release the On/Off Trigger.
Note:
Do not force the tool or apply side pressure to
elongate the hole. Let the tool do all the work.
PROPER USE
This tool is intended for use in a DIY (Do It Yourself)
context or for hobbyist purposes. It is not built for
continuous daily use in a trade or professional
capacity.
Before using the machine, carefully read these
instructions, especially the safety rules to help ensure
that your machine always operates properly.
Before attempting to operate the machine, familiarise
yourself with the controls and make sure you know
how to stop the machine quickly in an emergency.
Save these instructions and the other documents
supplied with this machine for future reference.
SETUP
Charging Your Battery
1. Plug the charging cable into the Charging Socket at
the bottom of the tool handle.
FIG. A
2. Plug the charging adaptor into the power supply.
3. The Charging Indicator on the front of the tool
handle will illuminate, indicating the battery is
charging.
4. The battery will take 3-5 hours to charge.
Note:
The battery status can be checked by pressing
the Battery Level Indicator.
FIG. B
WARNING!
Do not overcharge the tool.
Never leave the tool unsupervised while
charging.
WARNING!
This charger must only be
used to charge product XSD-363 (Model:
WJA-Y050500500W).
Fitting Driver Bits
1. Slide the required driver bit into the Magnetic Hex
Chuck.
2. To remove the driver bit, simply pull the bit out of the
Magnetic Hex Chuck.
WARNING!
Do not handle driver bits or
other accessories without gloves as they
are sharp and can become hot after use.
WARNING!
The power supply for this
charger should be protected by a residual
current device (rated 30mA or less).