11 (16)
TRI-AMPING
When tri-amping, all the metal plates between the
terminal screws should be removed.
See drawing below
Links/Jumpers for
Active/Passive
drive
To change between passive and active drive, just
remove the links/jumpers.
When the jumpers are removed the passive cross over is
disconnected.
Below are drawings that show what links/jumpers that
control the connection to the drivers.
From the left: Woofers.
In the middle: Midrange
To the right: Tweeter
When the link/jumper is in place, the construction is a
normal passive speaker. Disconnecting the jumpers will
allow direct connection with the drivers.
When disconnecting the link/jumpers, active
filters is a must. Without this the tweeter will be
destroyed. See next page!
Picture below shows a setting for active drive.
No links/jumpers are used.
Picture below shows a setting for passive drive.
Links/Jumper configuration:
From the left: Woofers.
In the middle: Midrange
To the right: Tweeter
