XTZ Atmosphere S2, Руководство пользователя

Страница: 7 / 16

7
Caution - Do not place the loudspeaker next to heat sources, such as furnace registers, radiators, etc.
- Do not place the loudspeaker near sources of excessive moisture, such as evaporative coolers,
humidifiers, etc.
Installation The connections for the loudspeakers are located on the rear of the unit. The figure down to the right
illustrates the input terminals of the loudspeaker with bi-wire and bi-amp options in addition to normal
single wire cable.
Connecting the speaker With the use of normal, single wire cable, the gold plated jumpers should be attached as shown in
the figure to the right. The speaker cable is connected to either the top or bottom pair of connectors.
Connect the same wire of the cable from + on the amplifier to + on the speaker and - on the amplifier
to - on the speaker. If you mix them you will introduce a polarity change resulting in degraded sound
quality, with cancellation of sound waves from the other channels. This is readily apparent as reduced
low frequency sound. For Bi-amp / Bi-wire connection, remember to remove the jumper to separately
connect wires to the LF and HF inputs.
Wall mounting The M6 has two key-hole type wall mounts integrated in the back baffle, see the figure below to the
left. It also has five sets of threaded inserts to attach the mounting bracket of your your choice, all with
a distance of 76 mm (3”) which are inted to be used with our Flush Mount Brackets, see figure here to
the right. This spacing is also widely compatible with many aftermarket mounting brackets. To the right
below is an figure illustrating how an M6 speaker looks mounted on a wall.
Note:
There are 2 sets(4pcs x2mm thick, 4pcs x6mm thick) of rubber spacers included with the M6. These can
be placed on the back of the speaker to prevent scratching the wall and allow for space to run speaker
wires. Choose the spacer thickness according to how far you need the speaker away from the wall.