• Install this product horizontally on a surface within 0 to 20 degrees tolerance
(within 5 degrees to the left or right). Improper installation of the product with
the surface tilted more than these tolerances increased the potential for errors in
the vehicle’s location display, and might otherwise cause reduced display
performance.
• When installing, to ensure proper heat dispersal when using this product, make
sure you leave ample space behind the rear panel and wrap any loose cables so
they are not blocking the vents.
• In order to prevent interference, set the following items as far as possible from
this product, other cables or leads:
- FM, AM antenna and its lead
- GPS antenna and its lead
- DAB+ radio antenna and its lead
- Digital TV antenna and its lead
In addition, you should lay or route each antenna lead as far as possible from
other antenna leads. Do not bind, lay or route them together, or cross them.
Electromagnetic noise will increase the potential for errors in the vehicle’s
location display.
• When installing, make sure you remove the two screws on the top of the product
(for those models with the disc loading drive). Otherwise the drive cannot accept
discs.
WARNING
Do not install this product in a vehicle that does not have an ACC wire or circuitry
available.
To avoid battery exhaustion
6
Be sure to run the vehicle engine while using this product. Using this product
without running the engine can drain the battery.