- 1 -
Unit removal:
1.remove front control panel.
2.slightly insert the key into the slot and gently to release.
3.separate the sleeve from the unit, keep release key in a safe place as
you may need for future removal of unit.
SETUP
- 20 -
C A R M O B I L E E N T E R TA I N M E N T
C A R M O B I L E E N T E R TA I N M E N T
Wiring Connection
TROUBLE SHOOTING
list has been made, consult your nearest service dealer.
Before going through the check list, check wiring connection. If any of the problems persist after check
This product incorporates copyright protection technology that is protected by method claims of certain U.S.
patents and other intellectual property rights owned by Macro vision Corporation and other rights owners.
Use of this copyright protection techn o l o g y m u s t b e a u t h o r i z e d b y M a c r o
vision Corporation, and is
intended for home and other limited viewing uses only unless otherwise author
i z e d b y M a c r o vision
Corporation. Reverse engineering or disassembly is prohibited.
No power.
Symptom
Cause
Solution
The car ignition switch is not
on.
If the power supply is properly connected
to the car accessory terminal switch the
ignition key to
ACC
.
The signals are too weak.
Select a station manually.
The antenna cable is not
connected.
Insert the antenna cable firmly.
The radio does not work.
The operation keys do not
work.
The built -in microcomputer
is no t operating properly
due to noise.
Press the RESET button. Front panel is
not properly fixed into its place.
Sound skips.
The installation angle is
more than 30 degrees.
Adjust the installation angle less than 30
degrees.
The disc is extremely dirty
or defective disc.
Clean the compact disc, then try to play a
new one.
The fuse is blown.
Replace the fuse.
Disc cannot be loaded or
ejected.
Presence of disc inside the
player.
Remove the disc in the player, then put a
new one.
Inserting the disc in reverse
direction.
Insert the compact disc with the label
facing upward.
Wiring is not properly
connected.
Check wiring connection.
The disc is extremely dirty
or defective.
Clean the disc or try to play a new one.
Temperature inside the car
is too high.
Cool off or until the ambient temperature
return to normal.
Condensation.
Leave the player off for an hour then try
again.
No sound.
Volume is in minimum.
Adjust volume to a desired level.
Inappropriate disk exiting
Unavailable disk entering.
push the exiting button for 5 seconds.
Notes:
RR:rear right (line out)
RL:rear left (line out)
RF:front right (line out)
LF:front left (line out)
Audio RCA Input
(Right & Left )
RED
WHITE
VIDEO
LINE OUT
SUBWOOFER
RR
RF
LF
RL
