manualshive.com logo in svg

xtremeracing THREE DEE VELOCITY, Руководство по монтажу и эксплуатации

Поделиться
Скачать
xtremeracing THREE DEE VELOCITY Скачать руководство пользователя страница 3

 

©

 xtremeracing.de 

- 3 - 

Version 1.0 

 

•

 

Now you can fit the landing skid. Invert the mechanics for better accessability. You have to fix the 
speed  landing  skid  firstly  on  the  rear  side  with  the  original  aluminium  bolt.  Thereby  you  have  to 
bend open the landing skid parts slightly and screw them in from both sides until they are tight. If 
necessary you have to lose them slightly so you can insert them into the front holes. Put each side 
in the front through the hole in the fuselage and through the side frame and tighten them with M4 
nut with thread lock. Because the acceleration during speed flight is not as high as during 3D you 
can leave out one or two aluminium bolts as battery mount. 

 

Содержание THREE DEE VELOCITY

Страница 1: ...the screws which are screwed into the tail boom Loose the screw of the tail support mount and remove the rear tail support including ball Remove the canopy spacer including rubber bump and replace it with socket cap screw M3x10 with flat washer Fix the tail support mount in 520mm distance from the rear tail boom clamping equal to original distance on the tail boom with the M3x18 two flat washers a...

Страница 2: ... fuselage To fix this position you can insert the long thread rod in the upper front mounting whole Next please check the holes in the rear Through to the setting of the back lash of the front bevel gears and fabrication tolerances in the length of the tail boom the exact bore position could not be defined there is a long hole at the rear If this still does not fit it has to be extended In this ca...

Страница 3: ...e landing skid parts slightly and screw them in from both sides until they are tight If necessary you have to lose them slightly so you can insert them into the front holes Put each side in the front through the hole in the fuselage and through the side frame and tighten them with M4 nut with thread lock Because the acceleration during speed flight is not as high as during 3D you can leave out one...

Страница 4: ...is behind and in front of the main shaft and not on the side During the last centimeters you should first insert the lower bolt into the corresponding borehole of the fuselage and then put the upper end of the hood to the fuselage Finally insert the upper bolts Through to the magnets the hood downright clicks onto the fuselage It may happen that at an extremely pitch angle generate vibrations whic...

Отзывы:

Нет отзывов

Бренды по названию

Популярные бренды

Загрузить еще бренды