XtremepowerUS 50130, Инструкция по эксплуатации и правила безопасности

Страница: 8 / 12

OPERATION
2. Removal
Remove the bolt with the provided wrench and remove the diamond wheel.
CUTTING
1.
Wheel guard adjustment
Adjust the wheel guard angle with the knob so dust and debris from the material or sparks do not
contact the operator during the cutting operation.
2.
Cutting Procedures
(1) Place this tool on the material to be cut and align the pre-marked line and the diamond wheel. The
culling can be pre-lined smoothly if you cut straight ahead on the line in the initial cut.
(2) T urn on the switch when the diamond wheel is not t ouching the material to be cut.
CAUTION
•
Always check the diamond wheel before starting work. Newer use a diamond wheel which is cracked,
broken or bent.
• Do not apply water or coolant to the diamond wheel.
• Start cutting only when diamond wheel reaches its maximum speed.
• lf the diamond wheel seizes or there is any abnormal noise, immediately turn the power off.
• Never use the diamond wheel to cut zig zag or curved lines.
• Never use the side surface of the diamond wheel.
• Never use to perform inclination cutting
• If excessive force is applied to the diamond wheel to make it align with the pre-marked line during
cutting, this might not only overload the motor and cause burn damage, but may also overheat the
diamond wheel and shorten the service life.
• Take care not to allow the power cord to come into contact with the diamond wheel during operation.
• When the work is completed, turn the power off and disconnect the power plug from the receptacle.
• Support the work piece in such a way that it is possible to predict what will happen, and so that the cut
remains open while cutting.
• Check that the blade is not in contact with anything when the machine is started.
• Always cut at the maximum speed
• Start cutting smoothly, allowing the machine to work without forcing or pressing the blade.
• Move the blade slowly forwards and backwards to achieve a small contact area between the blade and
the material to be cut. This reduces the temperature of the
blade and ensures effective cutting.
7