XtremeAIR Ultra Series, Руководство по установке и Руководство пользователя

Страница: 8 / 14

www.XtremeAirUsa.com PAGE
8
.
RANGE HOOD OPERATION
BEFORE YOU BEGIN (important): this machine is equipped with TOUCH SENSITIVE CONTROL, so please
1. DO NOT PRESS. Only TOUCH & HOLD DOWN 1 SECOND for every change makes.
2. TOUCH A WHOLE BUTTON only, please see below picture wrong vs. right
NOTE: For best results, start the range hood before cooking and allow it to operate several minutes after the
cooking is completed to clear all smoke and odors from the kitchen.
Step 10: Install baffle filters
Install baffle filters; refer to left picture for the following three steps:
1.Angle baffle filter toward back of hood.
2.Lift a baffle filter up above horizontal level.
3. Slide forward into slot behind the front of hood.
To remove the baffle, please reverse the process.
Step 9: Install oil tunnel or oil container (not available for all models)
Drop oil tunnel into recess support near rear of hood. Refer to the left picture
RIGHT: a whole button is
covered by a finger
WRONG: Only half of a button
is covered by a finger
RIGHT
VS.
WRONG
Step 7: Secure the hood-continue
Secure the hood by using 1 7/8” provided screws though the back of the hood to
the studs (use stud finder to find the stud and use 1/8” drill bit to drill though the
back of the hood)
CAUTION: Make certain the range hood is secure before releasing!
Step 8: Connect ductwork
•
Connect the exhaust on the hood to the ductwork about. Use aluminum tape to make all joints
secure and tight.
Oil Tunnel
Side View
Baffle Installation Side View
10