5
STEP 6: SECURE THE HOOD TO WALL
Use stud finder to find the stud and use 1/8” drill bit to drill though the back of the hood.
Secure the hood by using 1 3/4” provided screws though the back of the hood to the studs.
Figure 1: Bracket Installed
(Customer Provided)
STEP 4: CREATE ACCESSES
Use a sawzall or keyhole saw to remove the bottom of the cabinet area where the
range hood will be located.
B.
Install mounting brackets
as shown in the left
Tip: please take a look figure 1 which will help you
to have an idea of how it will look like.
Attach a L
bracket to back row rivet on the top of
range hood by 7/8” provided bolt with washer then
tight this L bracket to the back of cabinet by 2”
provided screw. Repeat this step for second L bracket
Attach a Face Frame
bracket to front row rivet on
the top of range hood by 7/8” provided bolt with
washer then tight this bracket to the cabinet face
frame by 1” provided screw. Repeat this step for
second bracket.
NOTE
: Adjust the mounting brackets so the hood can
fit correctly and securely on the cabinet frame.
STEP 3: PREPARE DUCTWORK & SINGLE OUTLET
Make sure you have a 15amp, 120V, 60Hz, single outlet on the left or right
of the duct pipe (usually is on ¼ of cabinet width).
Make sure duct pipe is ready to hook up to the range hood before
beginning installation (8” diameter duct, and roof or wall cap, depending
on where you will be venting your hood).
STEP 5: ATTACH THE HOOD
A. Lift the hood up
and have it
placed below the cabinet. Make sure
to center the hood beneath the
cabinet.
TIP (optional)
: since the hood is
heavy, a cabinet or a car jack is highly
recommended.
STEP 7: CONNECT DUCTWORK
Connect the exhaust on the hood to the ductwork. Wrap with aluminum tape to make all joints
secure and tight.
Brackets Installation Diagram
