Xtreme X-160, Руководство пользователя

Страница: 9 / 17

9
BATTERY USE

The Battery Housing should always be ventilated during charging to allow potentially explosive gasses to
dissipate. Before removing/attaching any battery cables always allow two minutes for any gasses to dissipate.

ALWAYS plug the charger jack into the charging socket first and then plug into the mains. When charging is
complete, unplug the charger from the mains first and then from the charging socket.

ALWAYS ensure the charger socket is DRY before plugging in a live charger.

NEVER place a battery in a sealed container when charging.

NEVER charge the battery near water.

If in doubt of the state of the battery, recharge it until the indicator on the battery charger indicates full charge.

ALWAYS charge the battery in a well-ventilated place where it is out of reach of children.

ALWAYS ensure the unit is dried thoroughly before opening the Nose Cone for charging or changing the
battery.
Charging the Battery
For charging the battery, follow these instructions.
1.
Always ensure that the Master Switch is OFF
– see Figure 2.
2. Always ensure that the sea scooter is out of the water and placed in a dry area.
3. Give a half turn to the Latches and remove them from the
Nose Cone as shown in Figure 4.
4. Remove the Outer Nose Cone and Buoyancy Control
Chamber.
5. Open the Vent by unscrewing the Vent Plug.
6. Remove the Inner Nose Cone. To do this, first feed the
silicone ring (provided with this manual) through the latch
holes in the Inner Nose Cone and hook over the hooks on the
Battery Housing
– see Figure 6. Then screw the Pump
Nozzle onto the Vent Hole and pump air into the Battery