User Guide
P.
9
3.
The parking lights will flash twice and the L.E.D. will come
OUT
,
indicating that the
vehicle is now out of valet mode.
Note
: Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
“Home Valet
TM
” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note:
Once the Home Valet Mode is activated, the vehicle will not start by remote
but the
OEM alarm functions will still be enabled.
To take the system i n t o Home Valet Mode:
•
Press the
LOCK
or
UNLOCK
button.
•
Within 3 seconds, press the
STOP
button until the Parking Lights go
out
To take the system o u t o f Home Valet Mode:
•
Turn the ignition key to the
IGNITION ON (RUN)
position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
•
Go
ON
then
OFF
; then
•
Flash
twice
, pause; then
•
Flash
twice
again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If your vehicle has an automatic transmission,
proceed as follows to set the system to
Turbo Mode:
1.
With the engine already running, press the
LOCK
button on the transmitter until the
parking lights come
ON
.
2.
Remove the ignition key from the ignition switch.
The engine will go on running.
3.
Exit the vehicle and close the door.
Press
the
TRUNK
button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine, to
activate Turbo Mode:
1.
Ensure that all the doors are closed and that the shifter is in the
Neutral
position.
2.
With the engine already running, apply the parking brake and release the brake pedal.
•
Make sure to release the brake pedal.
3.
Within 20 sec. press
LOCK
,
UNLOCK
or
START/STOP
on the transmitter.
•
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press and hold either:
a.
LOCK
to lock the doors and shut down the engine after 60 sec.;
b.
UNLOCK
to unlock the doors and shut down the engine after 60 sec.;
c.
START/STOP
to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
D.
TRUNK TO SET THE VEHICLE INTO IDLE MODE