NXRTi USER’S MANUAL
UNINTERRUPTIBLE POWER SUPPLY (UPS)
Xtreme Power Conversion Corporation (Rev 8/29/13)
Page 9
SYSTEM CONFIGURATION
The UPS device and the internal batteries make up the system. Depending on the site and load
requirements of the installation, certain additional options are available for the solution.
Planning a UPS system, the following should be taken into consideration:
•
The total demand of the protected system shall dictate the output power rating (VA). Allow a
margin for future expansion or calculation inaccuracies from measured power requirements.
•
Backup time required will indicate the battery size needed. If the load is less than the UPS
nominal power rating, then actual backup time is longer.
•
The following options are available:
o
Extended Battery Packs
NXRTi-EBP1 for 1000
NXRTi-EBP2 for 2000
NXRTi-EBP3 for 3000
o
Connectivity Options –SNMP/WEB card
o
Xtreme Power Distribution Units (XPDU)
See the Specification section of this manual for additional model information.
NXRTi-series FRONT VIEW
NXRTi-1000 REAR VIEW
