9
ASSEMBLY
3.
Repeat the procedure to complete assembly of all four sections. Fully tighten all screws.
Step 9 - Attach Reflector Assembly to Studs
1.
Support the heater then slide three large
flat washers
over the threaded end of the studs.
3.
Locate the reflector assembly on three studs.
4.
Install large,
flat washers
on studs and securely tighten the wing nuts but do not over tighten them.
Step 10 - Connect Hose and Reflector to Cylinder
NOTE:
You must provide propane gas and the propane cylinder. Use a 20lb cylinder only.
NOTE:
Use this heater only with a propane vapor withdrawal supply
system.
The minimum permissible gas supply pressure of 10 W.C. is required for
the purpose of input adjustment.
The minimum hourly of 17,000 BYU’s is the required input rating for a
heater for automatic operation at ratings less than full input rating.
The pressure regulator and hose assembly supplied with the appliance
must be used.
The installation must conform with local codes, or in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1.
The propane cylinder must be constructed and marked in accordance
with the specifications for LP Gas Cylinders of the US Dept. of
Transportation.
Содержание 96050
Страница 5: ...4 PARTS DIAGRAM ...
Страница 14: ...TROUBLESHOOTING 13 ...