MAINTENANCE
3
Unplug from electrical supply source before cleaning.
1. Clean the blade by using a soft, damp cloth then wipe with dry cloth. Please be caution around
the motor housing area.
2. Do not allow the motor or other electrical components to be exposed to water. Reassemble after
cleaning by reversing above procedure.
3. Do not bend the blades.
4. Put several drops of sewing machine oil into the oil ways on the front and rear shells at regular
intervals.
5. Recommendation: every 3 months with 24 hour use or every 6 month with regular use
Lubrication: The motor is pre‑lubricated at the factory and requires no additional oil.
To Clean Fan Blade or Grill:
CAUTION!
Before cleaning the fan be sure to disconnect power cord from the plug. Clean the
grille surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners.
DO NOT
IMMERSE THE FAN OR ANY WIRES IN WATER.
Replace front grille before fan use. Allow fan to
dry completely before use. Periodic grille cleaning with a vacuum will prevent dust build up. The
motor is sealed and does not require any interior maintenance, cleaning or lubrication.
MAINTENANCE:
The Internal motor bearings are permanently lubricated at the factory and do not
require any additional lubrication.
REPAIR: DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN PLACE. DO NOT USE THE
FAN IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE:
Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage
during storage.
Care and Maintenance Cleaning:
This product employs overload protection (fuse). A blown fuse indicates an overload or short‑circuit
situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user
servicing instructions (follow product marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short‑circuit may be present and the product should be discarded or
returned to an authorized service facility for examination and/or repair.
FUSE REPLACEMENT:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on
cord.
2. Open fuse cover by sliding open fuse access cover on top of attachment plug towards blades.
See Fig. 2.
3. Remove fuse carefully. Use a small tool to pry the end of the fuse from holder cavity. Be careful
not to break glass window.
4. Replace fuse. WARNING: Risk of fire. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt
fuse (3.6mm x 10mm). Be sure fuse is properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed position.
