OPERATION
2
Operating Instructions:
1. Adjust the desired speed by rotating the switch: 0‑‑Stop, 1‑‑Low, 2‑‑Medium, 3‑‑High.
2. Adjust the tilt angle by rotating the guard. Loosen the knobs before rotating and tighten after rotation is
set.
Assembly Instructions:
1. Align the screw hole on the side of the fan head, with the rubber ring, and the hole on the support frame,
then insert the screw knob to tight them up. Same operation to the other side of the fan head (fig.1, 2)
2. Loosen the screws, nuts and washers on A and B on the clamping support (fig.3,4)
3. Insert the end with screw holes of the inner pole into the clamping support. Align the holes on the clamping
support and the inner pole.(fig.5, 6)
4. Insert the screw through the holes on the clamping support and inner pole with washers. Tight up with the
nut. After step 4, you can get a fan head assembled like fig. 8.
6. Align the hole on the base with the one on the clump weight. Then insert the L‑shape screw bolt through
the holes with the big washer. (fig.11,12)
5. Insert the end of the outer pole into the base hole. (fig.9, 10)
7. Insert the decorating cap through the outer pole (fig.13)
8. Insert the inner pole into the outer pole. And tight up the screw on the plastic holder (fig.14) IMPORTANT:
THERE IS A SPRING COIL INSIDE THE OUTER HOLE. DONOT TAKE IT OUT DURING ASSEMBLING.
Loosen the screw knob on the inner pole and adjust the fan to the height you want, then tight up the screw
knob. (fig.15)
