ASSEMBLY
STAND AND BASE ASSEMBLY
1.
Place stand assembly with the spring on the base frame and align the holes in the coupler
with holes in the base frame.
2.
Insert screws and spring washers from the screw package and tighten securely.
STAND ASSEMBLY
1.
Make sure the spring is in the stand assembly.
2.
Remove the two screws from the extension pipe adjuster.
3.
Insert the extension pipe into the stand pipe.
4.
Align the two holes on the stand pipe with the holes on the adjuster and secure the
adjuster with the two screws removed in step 2.
5.
Adjust the extension pipe to desired height.
STAND/MOTOR ASSEMBLY
1.
Remove the bolts, flat washers and nuts from the extension pipe.
2.
Align the upper round hole on the extension pipe assembly with the upper round hole in
the motor bracket on the motor.
3.
Insert the bolt and replace the flat washer and the nut removed from step 1.
4.
Adjust tilt to desired angle and insert the bolt through the lower square hole on the
extension pope assembly with the cambered slot in the motor bracket on the motor and
replace the flat washer and the nut removed from step 1.
5.
Tighten the bolts and nuts.
6.
Repeat step 3-5 to adjust the airflow upward or downward.
REAR GRILL AND BLADES ASSEMBLY
1.
Remove the four screws, spring washers and the flat washer from the motor shaft.
2.
Align the rear guars over the threaded holes in the motor. Align the rear guard so that the
one small hole in the outer ring is located to your lower right when facing the fan.
3.
Secure with the flat washers, spring washers and the screws removed in step 1.
4. Remove the screw on the blade’s circular slot and carefully slide the blade assembly over
the shaft. Then replace and tighten the screw to fix the blades on the groove on the shaft.
5. CAUTION:
Do not alter the angle of the blades, or bend them in any manner.
FRONT GRILL ASSEMBLY
1.
Open the clips on the front of the guard.
2.
Hang the front guard on the top rib of the rear guard by utilizing the U-shaped fixed clip
on the top of the front guard.
3.
Insert and secure the safety guard bolt, spring washer and nut.
4.
Press the clips down around the front guard to secure.
3
