PRODUCT INFORMATION / PARTS LIST
OPERATION
WARNING:
Using pure gasoline will damage the engine. When refilling, make sure the fuel is the correct
MIXING FUEL
2.
Pour in the rest of gasoline and agitate it again for at least a minute. Some oils may be more difficult to
agitate than others depending on their ingredients. Failure to fully agitate the oil can result in piston seizing.
1.
Press the primer pump until the fuel goes back into the fuel tank.
4
WARNING:
Fuel will corrode if it is under the influence of UV or high temperatures for extended periods.
Mixed fuel should be used within 30 days.
WARNING:
Using fuel with water will corrode the engine and carburetor.
NEVER
allow water to enter the fuel
tank.
IMPORTANT:
Measure out the quantities of gasoline and oil to be mixed is 40:1.
1.
Put the gasoline in a clean container. Pour in all the oil and agitate it well.
IMPORTANT:
Make sure to select bare ground for fuelling. Make sure the fuel tank is fastened securely. Wipe
up all spills before starting the engine.
IMPORTANT:
Before starting the engine, move at least 3 meters away from the fuelling site. Make sure
to inspect the entire unit for loose fittings and fuel leakage. Make sure the cutting attachment is properly
installed and securely fastened.
When starting the engine, place it on the ground in a flat, clear area and hold it firmly in place so as to ensure
that the cutting part doesn’t contact any obstacles.
The cutting attachment will begin to rotate as soon as the engine is started by putting the throttle to the
START position.
After starting the engine, check to make sure the cutting attachment stops rotating when the throttle is moved
fully back to its original position. If not, stop the engine and check the throttle cable and the adjusting bolt of
the carburetor. Remove the blade cover before starting.
2.
Move the choke lever to the closed position.
3.
Put the machine on a firm, flat ground surface. At first, slowly then pull the throttle quickly.
4.
After starting the engine, return the throttle spanner.
5.
Allow the engine to run for 1-2 minutes to let it warm up. When the engine is hard to start due to excess
fuel, remove the spark plug and dry it, then restart it.
STOPPING THE ENGINE
STARTING THE ENGINE
1.
Release the throttle lever to allow the engine to idle for 1-2 minutes.
2.
Put the stop lever in the STOP position.
3.
Put the machine on a firm, flat ground surface. At first, slowly then pull the throttle quickly.
USING THE HANDLE
1.
Free the handle by pulling the locking lever.
2.
Turn the handle until the locking lever clicks into place.
3.
When the handle is locked in its new position, now you can begin work.
WARNING: DO NOT
use for trimming when the handle is pulled.
Содержание 81066
Страница 6: ...TROUBLESHOOTING and MAINTENANCE 5 ...
