5
1. POWER SOURCE:
Ensure that the power source to be utilized conforms to the power requirements
specified on the product nameplate.
2. GROUNDING:
This tool should be grounded while in use to protect the operator from electric shock. This
tool is equipped with a three-conductor cord and grounding plug to fit the proper grounding receptacle. The
green (or green and yellow) conductor in the cord is the grounding wire. Never connect the green (or green
and yellow) wire to a live terminal.
3. POWER SWITCH:
Ensure that the power switch is in the OFF position. If the plug is connected to a
power receptacle while the power switch is the ON position. The power tool will start operating immediately,
possible causing serious injury.
4. EXTENSION CORD:
Use ab extension cord of sufficient thickness and rated capacity. The extension
cord should be kept as short as possible.
5. FEEDING OIL:
Prior to using the power tool, remove the oil gauge. This product contains only a small
amount of oil when shipped from the factory.
6. MOUNTING A TOOL:
Standard tools are recommended for proper operation.
PRIOR TO OPERATION
1.
Rotate the Stop Lever 180° in a clockwise direction while pulling toward you. Next, insert the tool shank
into the hexagonal hole on the front cover.
2.
Clamp the tool by turning the stop lever half a turn in the opposite direction.
NOTE:
When removing the tool, follow the above procedure in reverse order.
USING THE HAMMER
1.
After placing the tip of the tool in the base, turn power witch to ON. In some cases, it may be necessary
to push up a bit against the crushing position forcefully in order to begin the striking stroke. This is not due
to a malfunction of the tool, it means the safe-guard mechanism against no-load striking is working.
2.
By utilizing the weight of the machine and by firmly holding the hammer with both hands, one can
effectively control the subsequent recoil motion. Proceed at a moderate work rate. The use of too much
force can impair efficiency.
CAUTION:
Sometime the tool does not begin the striking stroke even when the motor rotates because the
oil has thickened. If this tool is used in low temperatures or if it being used after extended idle time. To avoid
this, run the tool for five minutes to warm it up before use.
BEFORE EACH USE:
Inspect the general condition of the tool.
CHECK FOR:
Loose hardware, misalignment or binding of moving parts, damaged cord/electrical wiring,
dull or cracked Chisel, cracked or broken parts, and any other condition that may affect its safe operation.
AFTER USE:
Wipe external surfaces of the tool with clean cloth.
OPERATION
Содержание 61108-XP
Страница 8: ...7 PARTS DIAGRAM ...
Страница 9: ...8 PARTS LIST ...
