Xtreme Power Systems X24, Инструкция по установке и эксплуатации

Страница: 4 / 53

SECTION 1 – X24 INFORMATION
Basic Details
This product requires the use of receivers that output a serial data stream.
If your receiver does not have a serial data stream output, it will not work
with this product! Currently, the following serial protocols are supported:
XPS Xtreme
Spektrum DSM2 and DSMX (
satellite receivers only )
Futaba SBUS and SBUS2
JR DMSS Mode A and Mode B
JETI UDI
Graupner HoTT SUMD
Multiplex SLRx
The X24 consists of a high speed microcontroller with voltage monitoring
capabilities, three push button switches, one external LED output, one multi-
colored internal LED (known as just
LED throughout this manual), an OLED
screen, four serial receiver inputs, four Spektrum satellite receiver
compatible inputs, two main power inputs, two switch inputs, one match
power input, and 24 servo outputs (two of which are powered by the BEC
power). The LED is a “RGB” type, allowing for virtually any color to be
displayed. Different colors and flashes are used to indicate various status
conditions.
Receiver Inputs
There are four main receiver inputs and four Spektrum compatible receiver
inputs. The main receiver inputs pass the input voltage directly to the
receiver(s). You will need to make sure that any receiver you are using can
handle the input voltage!
Some older receivers can be destroyed . The
Spektrum compatible inputs pass 3.3v to each receiver, which is required for
all Spektrum and compatible satellite receivers.
BEC
The BEC voltage is programmable as either 5v or 6v, and appears on both
the D2 and E2 outputs at the same time. This voltage can be used to drive
anything requiring current up to 3A. Some example uses are ignition boxes
for gas engines, LED lighting, or servos that can not handle more than 5v.
4