19
!
WARNING
To prevent SERIOUS INJURY or DEATH from electrocution:
-
Power MUST NOT be connected until instructed.
To prevent SERIOUS INJURY or DEATH from using the Wall Panel or Push Button and a closing door:
-
Install the Wall Panel or Push Button within sight of the door at a minimum height of 5 feet (1.5m)
above the floor. Make sure it is out of the reach of children and moving parts of door and hardware.
-
NEVER permit children to access the Wall Panel, Push Button or remote Transmitters.
-
Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.
-
ALWAYS keep a moving door in sight until it’s completely closed.
-
NEVER cross the path of a moving door.
Drywall Anchor
Screw #6 x1”
Wall Panel
Fig. 1
Connecting Wall Panel
The Wall Panel is a wired, illuminated door control placed inside
your garage.
To install the Wall Panel:
1.
Inside your garage, install the back plate of the Wall Panel
within sight of the door at a minimum height of 5 feet
(1.5m) off the ground. Ensure it is installed out of the reach
of children and free from the moving parts of the door and
hardware.
2.
Fasten it to a solid surface with 1” screws. If attaching to
drywall or other hollow surface, drill 3/16” holes and use
the provided Drywall Anchors.
3.
Snap the Wall Panel onto the back plate.
To Connect the Wall Panel to the Opener
Connect the plug from the Wall Panel to the “Wall Panel” outlet
on the rear of the Opener, as shown in Fig.2.
Fig. 2
Light
UNLOCK
LOCK
Using the Wall Panel
(ONLY after installation is completed )
Door
—
Press and release to access the door
Vacation Lock
Unlock
— Sliding to the left
ACTIVATES
all remotes,
wall panel and accessories and dims the
red illuminated wall panel main button.
Lock
— Sliding to the right
DEACTIVATES
all
remotes, wall panel and accessories and
brightens the red illuminated wall panel
main button.
Light
— Turns the courtesy light On/Off
From Wall Panel
Wall
Panel
1
2
Check illumination after
connecting power
NOTICE: This openers wall button will not work until you set the travel limits and the auto force adjustment.
You must follow all steps located on pages 16,17,18.
DO NOT PLUG
WALL PANEL
IN HERE
ACC
PORT
Slide
Place the wall panel
a minimum of 5ft (1.5m)
above the floor
