21
!
WARNING
To Prevent SERIOUS INJURY or DEATH:
-
Keep Transmitter and battery out of reach of children.
-
NEVER permit children to access the Wall Panel, Push Button nor remote Transmitters.
-
Operate the door ONLY when it is properly adjusted, and there are no obstructions present.
-
ALWAYS keep a moving door in sight until completely closed. NEVER cross the path of a moving door.
To reduce risk of fire, explosion or electric shock:
-
DO NOT short circuit, recharge, dissemble or heat the battery.
-
Replace with 23AE 12 Volt batteries ONLY. Dispose of batteries properly.
Programming Hand
-
held Transmitter
To Program Transmitter(s):
1.
Press/release the “LEARN” button on the rear control
panel, “OK” LED will glow and beep. The unit is now ready
to accept a transmitter in the next 30 seconds as shown in
Fig.2.
2.
Press/release the large grey button on the Transmitter.
(Additional buttons used for multiple garage door openers)
3.
The “OK” LED will flash and beep twice indicating
transmitter is stored successfully.
Up to 20 Transmitters (including wireless keypad codes) can be
added to the unit by repeating the above procedures.
If more than 20 Transmitters are stored, the first stored
Transmitter will be replaced. (i.e. the 21st Transmitter replaces
the 1st stored Transmitter.)
Removing ALL Transmitters:
To remove ALL Transmitters from memory, press and hold the
“LEARN” button for 5 seconds. The “OK” LED will flash and
beep 2 times indicating ALL transmitters have been removed
from memory.
Replacing Transmitter Battery:
When the battery of the hand held Transmitter is low, the
indicator light will become dim and/or the range of the
Transmitter will decrease. To replace the battery, remove the
battery cover from the Transmitter as shown in Fig 3. Replace
with a 23AE 12 volt alkaline battery with polarity shown in Fig.3.
This device complies FCC Rules for HOME OR OFFICE USE. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Fig.1
Fig.3
Signal and Bat-
tery Indicator
23AE 12 Volt
Alkaline Battery
Visor Clip
+
-
Fig.2
LEARN
30
seconds
OK
1
2
OK
3
x2
Flashes x2
NOTICE: This openers transmitters will not work until you
set the travel limits and the auto force adjustment.
You must follow all steps located on pages 16,17,18