www.XtremeAirUsa.com
PAGE
5
STEP 3: PREPARE DUCTWORK & SINGLE OUTLET
Make sure you have a 15amp, 120V, 60Hz, single outlet on the left or right of the duct pipe
(usually is on ¼ of cabinet width).
Make sure duct pipe is ready to hook up to the range hood before beginning installation (8”
diameter duct, and roof or wall cap, depending on where you will be venting your hood).
STEP 8: CONNECT DUCTWORK
Connect the exhaust on the hood to the
ductwork. Wrap with aluminum tape to make
all joints secure and tight.
STEP 5: PREPARE STRIPS FOR MOUNTING BRACKETS
Prepare two wood filler strips as shown in the left figure (10” x
1 1/2”” x 1/2”).
Attach 2 strips to the sides of the cabinet (1 at each side) and
secure with 3 screws (NOT PROVIDED).
STEP 4: CREATE ACCESSES
Use a wall or keyhole saw to remove the bottom of the cabinet area where the range
hood will be located.
STEP 6: ATTACH THE HOOD
Lift the hood up and have it placed
below the cabinet. Make sure to
center the hood beneath the cabinet and
flush with the front of the cabinet.
TIP (optional)
: since the hood is
heavy, a cabinet or a car jack is highly
recommended.
STEP 7: INSERT MOUNTING BRACKET
At each corner, install the bolt, nut, washers and mounting
bracket as shown in the left figure.
NOTE
: Adjust the mounting brackets so the hood can fit
correctly and securely on the cabinet frame.
Washer
Washer
Mounting
Bracket
Body Frame
Mounting
bracket
