12 Connect the power used by the cable shall ensure that there is sufficient capacity,the use
of a terminal insulation casing.
13.After Long time preservation to use this equipment , must be checked and trial run before
use.
14.When the power supply has been delivered or the machine is running, do not open the
distribution box and junction box.Otherwise, electric shock may happen, cause personal
injury; at the same time on the machine is not near the arc welding operation. Otherwise,
easy cause the machine break down.
15.When the distribution box has been opened or bare wire, not running the machine and its
ancillary facilities.
Otherwise, may be affected by the high voltage terminal or bare wire in the electric shock,
mJury.
16.In addition to the regular inspection or wiring, other any time all can not open the
electrical equipment shell. Otherwise, may damage the equipment, affecting the normal
operation of the machine.
17.When connect cable or inspection regular,should be operating in the demolition of the
input power for at least 10 minutes.Otherwise, electric shock may happen, resulting in
personal injury.
18. The machines must be reliable grounding, grounding resistance less than 100 ohm.
Otherwise, electric shock may happen, resulting in personal injury.
19 .don't make cable by scratches, extrusion, over voltage and over load. Otherwise,electric
shock may happen, resulting in personal injury.
20.The machine please do not contact with water and steam, wet hands is best not to touch,
with dry hands start switch. Otherwise, electric shock may happen, resulting impersonal
lilJUry
21.Substrate, switch, frequency converter, motor drive circuit, the program in the terminal
state, the absolute prohibition of tested with high resistance tester. Otherwise lead to
machine failure or accident.
22.Before using the machine, please clean up the environment, should not have dangerous
goods etc ..
23.Clothing is without prejudice to the operation, try to light. Especially the work shirt cuff
must fasten, cannot open.
24.The machine after electrify, throughout the enclosure removed and put in his hand and
other occasions, the risk may be involved.
25.Electricity, pay attention to high temperature mark, when the hand does not pay attention
to the touch, may cause bums. Shaft and other parts of the machine prominent, do not pay
attention to.
XtraVac RBF8 Rotary Bagger Operation, Service, & Parts Manual
XtraVac Packaging Machines
RBF8 - Rotary Bag Filling & Sealing Machine
419 E. 11th Ave. North Kansas City, MO 64116 USA
+1 800-728-2999 • [email protected]
