VIS-IR Thermography Detector Product Guide
Xtralis
36218_A2
10
Adjusting Camera Position
If any adjustments are required for the camera positioning, loosen the screws, adjust the position and then
tighten the screws using Torx T10.
Figure 8: Adjust Camera Position
Wiring
The junction box can be pre-mounted and field wiring can be done by an electrical contractor prior to the
detector installation and commissioning. The connectors for the field wiring are push-in type connections, fitting
0.2~0.75 mm 2/24~20 AWG wires. The cables coming from the detector are fitted with connectors that simply
plug into the termination board.
The Ethernet cable is fitted with a female RJ connector.
Figure 9: Female RJ Connector
