Xtralis VESDA ECO, Руководство по эксплуатации продукта

Страница: 19 / 96

VESDA ECO Detector by Xtralis
17898_05 Installation
Mechanical Installation
Do not install your ECO detector if there are any signs of shipping
damage. Inform your distributor if there is any visible damage.
Check the Model of ECO Detector is correct as per design specifications for the
site. Refer to the Model number located on the main product label
the gas types and ranges are of the correct specification.
Follow the steps below to fix the Detector to the pipe work
•
Before fitting the ECO unit to the pipe work, ensure that any glue used in
fixing the pipes has been given sufficient time to cure such that it any
vapours from the glue will not affect the gas detection.
•
At the preferred location within the pipe work, as determined by reference
to the previous section of this document, remove a straight
the pipe. The exact length of pipe to be removed will depend on the
tolerances of the pipe-work being used, but as a guide the lengths are
approximately
o
60 mm when installing in a 25mm OD pipe
o
4 inches (100 mm) when installing in a ¾” BPS pipe
It is suggested that the pipe is cut to permit subsequent adjustment if
required, to maintain a good airtight fit.
•
Ensure that the cuts on the pipe are perpendicular to the pipe and that
there are no burrs or sharp edges present. If so, trim the pipe to remove
these.
•
Verify correct orientation of ECO detector, that the flow arrow on the side
of the ECO enclosure is in the same direction as the sample airflow
•
Insert the detector into the open segment of the pipe, ensuring that the
pipe entry to the detector is square and the pipes sit correctly in the
tapered receptacles to provide a sufficient air tight seal between them
•
DO NOT GLUE THE PIPES TO THE DETECTOR. This is not necessary
and is an obstacle to future maintenance
•
If the gas test port is not to be permanently connected, ensure that the
blanking plug supplied with the unit is fitted firmly in place.
•
Alternatively, if a permanent connection is to be made to the gas test port,
use 6mm OD pipe to connect to the integrated pipe interface
is securely fitted and that it is closed at the opposite end during normal
operation.
•
When mounting the ECO detector, ensure that device is oriented such th
the Status Indicators are visible for inspection purposes.
Product Guide
9
Do not install your ECO detector if there are any signs of shipping
Inform your distributor if there is any visible damage.
ECO Detector is correct as per design specifications for the
label and ensure that
Before fitting the ECO unit to the pipe work, ensure that any glue used in
fixing the pipes has been given sufficient time to cure such that it any
work, as determined by reference
a straight section from
will depend on the
work being used, but as a guide the lengths are
pipe
It is suggested that the pipe is cut to permit subsequent adjustment if
cular to the pipe and that
the pipe to remove
the flow arrow on the side
is in the same direction as the sample airflow.
sert the detector into the open segment of the pipe, ensuring that the
pipe entry to the detector is square and the pipes sit correctly in the
to provide a sufficient air tight seal between them.
This is not necessary
If the gas test port is not to be permanently connected, ensure that the
blanking plug supplied with the unit is fitted firmly in place.
to the gas test port,
use 6mm OD pipe to connect to the integrated pipe interface, ensure that it
is securely fitted and that it is closed at the opposite end during normal
device is oriented such that