64
Doc. 20780_03
Planning and Commissioning Manual
ADPRO Passive-Infrared (PIR) PRO Series by Xtralis
4. Detector’s status, it is represented with an arrow which color changes according to
the current status as follows:
: OK
: Fault
: Synchronizing
NOTE!
Display of DIP-switches may vary depending on detector model.
DIP-switches values are controlled from the detector itself. A table that
shows the switches functions is available on a sticker on the detector’s
lid.
You can control the Scope view through the following:
Action
Button
Shortcut
Run the Scope
Run
<F5>
Stop the Scope
Stop
<Ctrl> + <F5>
Select Scope view mode
Scroll Mode
<F6>
Grid <F7>
Increase signal speed
Step up++
<F8>
Decrease signal speed
Step down- -
<Ctrl> + <F8>
Clear Scope view
Clear
<F9>
Delete all triggers
Trigger Delete ALL
<F10>
As shown in the table above, there are two scope modes:
Scroll Mode
: If checked, the signal is continuous and its direction is from right to left. If
unchecked, the signal’s direction is from left to right and each time <F6> key is pressed
the signal starts from the beginning.
To switch between Scroll modes press <F6>.
Grid:
If selected, horizontal and vertical lines appear on the Scope in addition to the
signals.
10.3.6
Tool
This menu enables you to take pictures of the scope and save them in the computer, view
statistics of alarm states, and identify communication problems, etc.
Tool
menu appears as follows:
The following sections discuss all the actions you can perform.