STEP 4:
Note:
If you are fitting the KickBack to an EdgeRunner and want to use the
default kickstand height, you can skip to step 5.
Measure the KickBack 3
Step 4a:
With the KickBack
legs in the down position,
measure the distance between
the mounting plate and the
ground (C).
Step 4b:
With the KickBack
legs in the up position, place
the rear wheel on something a
half inch above the ground (a
larger wrench works great) and
take the same measurement
(D).
Step 4c:
Subtract your measurement (D) from your measurement (C) and write
down the result: __________
C
D
STEP 5:
Step 5a:
Remove the rubber feet and plastic
end plugs from the KickBack’s legs
Step 5b:
If you are installing on an EdgeRunner: you can
cut the legs 3 inches (76 mm) from the bottom.
This will leave a little over half an inch between
the tire and the ground.
Cut the Legs
STEP 5 Cont’d:
If you’re installing on another Xtracycle or want to fine
tune things, measure up the distance you calculated
in Step 4c from the bottom of each leg and mark that
location to cut.
NOTE: Sometimes the markings on the KickBack legs are
inconsistent, always double check that your cuts are even
with a ruler.
Step 5C:
Cut each leg where
appropriate. A pipe-cutter
is the easiest solution, but a
hacksaw and clamp-on guide
will also work.
STEP 6 Finishing Touches:
Replace the end caps and rubber feet. Enjoy your new steady steed!