STEP 1:
If your Xtracycle has a threaded
boss on the underside of the
boom tube (A), just ahead of
the front bridge: start to thread
one m5 bolt into it far enough
to keep the KickBack attached
to the frame. Do not tighten.
Hold the Stand in Place
If it does not: fasten the
included BoomStrap over the
boom tube with two M5 bolts.
Do not tighten.
STEP 2:
Step 2a:
With the KickBack legs
folded up, place both Xtracycle
BridgeBolts over the Xtracycle’s
front bridge (B).
Step 2b:
The front, left BridgeBolt
leg passes through a rectangular
cutout. Place the rectangular
washer over this leg, then lightly
thread on a washer and nut.
Step 2c:
Thread a washer and
nut onto each of the other three
BridgeBolt legs.
Install the Bridge Bolts
STEP 3:
Step 3a:
Moving the legs
as necessary, lightly snug all
four nuts with a 10mm socket
wrench. Alternating between
nuts can keep the KickBack
from pulling to one side or the
other.
Tighten Things Down
Step 3b:
Put the legs into the
down position and pull them
towards the front of the bike
to ensure that the KickBack
is rotated as far forward as
possible and centered on the
boom tube (A).
Step 3c:
Tighten the M5 bolts
on the BoomStrap or the single
M5 bolt below to 3Nm.
Step 3d:
Torque all four nuts
to 6 Nm.
Note:
You will need to lower the stand
to access two of the BridgeBolt legs.
B
A
A