Xtool D1 Pro, Быстрый старт

Страница: 20 / 27

28 27
Adjust the tension of the timing belts
Set the position of the laser module
Put the focal length
setting bar down
Loosen the thumb screw on
the other side and slide the
laser module upward
or downward
After determining the position,
tighten the thumb screw and put
the focal length setting bar back
Set up xTool D1 Pro
Try to set the timing belts on the right and left plates to the same
tension, so that xTool D1 Pro can cut and engrave materials properly.
Tighten
Loosen
Lock
Unlock