XTM XTM477PK, Руководство пользователя

Страница: 8 / 20

8
RADIO OPERATION
Turn Volume Control CLOCKWISE to switch the radio ON (REFER TO PAGE 6 FIG. 1)
Rotate Volume control clockwise to increase the volume. (REFER TO PAGE 6 FIG. 1).
Volume levels 1-15.
Press the Channel Up and DOWN buttons to scroll through to desired channel. For your
reference a list of the available channels, corresponding frequencies and guidelines
for their use and selection is printed on page 15. For Australia, channels 05 and 35 are
reserved for EMERGENCY CALLS ONLY.
POWER ON/OFF
VOLUME CONTROL
CHANNEL SELECTION
Capable of muting the car stereo when you receive incoming traffic on the transceiver.
Mute out wires present a Zero Ohm Short circuit when Squelch is OPENED - Black wire
MUST go to Ground/ Earth side of mute circuit
MUTE OUT
Short press of CALL button transmits Selcall CTCSS / DCS tones (If enabled in menu
settings)
CALL Button (On Microphone)
Short press of INST button switches radio to preset INST ant channel.
DEFAULT INST channel is 09. This can easily be changed by selecting another channel
and then pressing INST for 2 seconds
Example : To select Channel 40 as INST channel
• Use the ▲ & ▼ Arrow buttons on the faceplate to select channel 40
• Press and Hold INST button for 2 seconds
Instant Channel is now Channel 40
INST Button (On Microphone)
SCAN mode (If enabled in menu settings)
Radio will scan through all 80 channels until it hears a transmission (Busy Channel)
Radio will stop on the busy channel until transmissions stop – the radio will then
commence scanning again.
To turn Scan OFF Short press S button again
S Button (On Radio Fascia)