WORK PREPARATION AND USE
When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment. Read all
instructions before using this tool!
1. When attaching the sanding device to your angle grinder, disconnect a corded one from the
power source.
2. Always disconnect the attachment from your angle grinder when cleaning or inspecting it.
3. Do not use in wet or damp locations.
4. Wear eye and hand protection when using and cleaning the wheel.
5. Wear a dust mask when operating.
6. Keep fingers and limbs away from the wheel when it is attached to your grinder.
7. Like any sanding tools, it can cause injury if not properly handle.
8. As with any power tool, the machine should be kept out of the reach of children
9. Always adhere to al l warnings and safety precautions provided with the angle grinder that this
attachment is to be used with.
Assembly
The tube polishing attachment is applied with M14-thread angle grinder, no load speed less than
4000rpm. Please ensure that the power is cut off and unplug the machine before the installation of
this burnishing attachment.
Method
:
Step 1
:
1. Choose the ring that is compatible with your angle grinder.
2. Place it to the right position.
a) Shroud locator
b) Optional rings (possible 0-6 rings)
Step
2:
1. Assemble the clamp of the polishing attachment onto the
ring. And tighten it with hex wrench tightly.
2. Make sure the locating pin is consistent with your grinder’s
clamp Or it HAS risks of belt-running out
c)
Triangular stand
d)
Locating pin
c
d
b
a