XTline XT102910, Руководство пользователя

Страница: 65 / 67

Replacing the nylon cord set
WARNING: Use nylon cord with diameter specified in “SPECIFICATIONS” only. Never
use heavier line, metal wire, rope or the like. Use recommended nylon cord only,
otherwise it may cause damage to the tool and result in serious personal injury.
WARNING: Make sure that the cover of the nylon cutting head is secured to the housing
properly as described below. Failure to properly secure the cover may cause the nylon cord
set to fly apart resulting in serious personal injury.
When using up the nylon cord, you need to replace with a new nylon cord set.
To replace a new nylon cord set , perform the following steps:
1. Depress the button of the cover both sides a little bit and then remove the old one.
2. Mount a new one by fitting it on to the original place with the nylon cord tip through
the hole.
3. Depress the button of the cover both sides a little bit again and then inset it into the
original place with a little click.
1
2
3
4
1. Cover of the nylon cutting head
2. Button of the cover
3. Nylon cord set
4. Hole
Storage
The hook groove in the tool bottom is convenient for hanging the tool from a nail or
screw on the wall. Before storing the tool, contract the wire guard, shorten the shaft,
adjust the pivoting head to a right angle, and then fold the front grip.
1
1. Wire guard