The polyfusion welding system allows heating of the outer surface of the pipe and the inner surface of the matrix
up to the requested temperature followed by inserting both parts into each other, resulting in the solid joint. Prior to
this operation, clean all surfaces from mechanical impurities using a non-synthetic material cloth. To set the
surface of a plastic pipe and matrix, the heating mirror is used, equipped with extensions of requested dimensions
(thorn and sleeve). After reaching the requested temperature, the thorn is applied to the neck and the proper pipe
size is inserted into the sleeve.
Do not rotate the pipe or matrix during the heating process. After the proper setup of the interface, remove the pipe
and matrix from the adapters and joint these by inserting simultaneously. Do not exceed the operation time
recommended by the pipe producer. Such period shall be as short as possible. A mild axial pressure is applied to
both components for approximately 10 seconds. Do not manipulate the joint until completely cooled down.
Cleaning and Maintenance
Do not use metal objects for cleaning of melting surfaces to prevent the damage of a teflon layer. Make sure to
clean using a wooden spatula or non-synthetic material cloth only. All service shall be carried out by authorized
personnel only.
Caution !
Run the tool maintenance only when disconnected from the power supply and completely cooled down (switching
off is not enough!). Do not use any solvents! Avoid all liquids to get in contact with the tool, such as when
cleaning or using in exteriors. The liquid intrusion may result in tool damage.
