XTline J1XL-DU11-255J, Руководство пользователя

Страница: 36 / 38

6. BEVEL CUT (SEE FIG 11, 12)
A bevel cut is made at 0° miter and any bevel angle in the range of 0° to 45° left.
lt can be made as either a chop cut ar a cross pull cut depending on the width of the workpiece.
The saw can be moved Irem the normal 0° perpendicular position to an angled position down to 45° Irem the
horizontal, on the left only.
Loosen the bevel lock lever [16] and tilt the saw head to the left, until the desired angle is reached on the bevel
scale. Re-tighten the bevel lock lever and make your cut.
7. COMPOUND CUT (SEE FIG J)
A compound cut is a cut requiring both a miter setting and a bevel setting. lt can be made as either a chop cul
ar a cross pull cut
depending on the width of workpiece.
Compound miter cuts can be achieved by setting both the miter and bevel angles simultaneously.
Follow the procedures for miter and bevel cuts to achieve the desired angles.
9. OPERATION INSTRUCTION OF LASER GUIDE (SEE FIG L 1, L2)
The laser guide (5] equipped with this machine is for the purpose of precision cutting.
Make sure the batteries are fitted in the laser guide before carrying out precision cutting. To fit the batteries,
remove the battery storage cover, insert 2xAAA
batteries, then replace cover.
NOTE: Ensure correct battery polarity. To use the laser guide, simply slide the laser
on/off switch al the 'T' position, the laser guide then projects a visible red line on the workpiece surface, make
your cut along the red line.
Switch off the laser after cutting.
The sawdust may "block" the laser beam, clean the laser generator periodically.
WARNING: Never stare directly into the laser beam and never point the beam at anybody.
DANGER: Laser radiation. Avoid direct eye contact with light source.