XTline 2-900F8, Руководство пользователя

Страница: 33 / 34

6. Movement
Before moving the compressor, make sure that the switch is off and
the power cord plug is unplugged from the socket. Grasp the handle,
lift the air compressor, move the air compressor to the desired
position, lower the handle, and ensure that the air compressor is on
a fiat ground. Note: Make sure your feet stand firm and seek help if
necessary.
7. Overload protection(Pic.G)
This product is equipped with an overload protection device. When
the working voltage is too low or too high, or working environment
is with high ambient temperature, the motor is overheated, the
machine will automatically cut off the power supply to protect the
motor. After that, the user need to turn off the power switch first,
wait for 3-1 O minutes and then press the red reset button
{depending on the cooling condition), then turn it on, the machine
can be used normally, if the button is reset, it still does not work
normally Wait for 30 minutes or more, and then start the motor after
it has cooled down completely.
G
MAINTENANCE
Before any maintenance or repair work, you must cut off the power supply and ensure that the air
tank is pressure-free, otherwise it is very easy to cause injury!!
1. Please clean and maintain the machine regularly.
2. lf the power cord is damaged, in order to avoid danger, it must be replaced by the manufacturer's
maintenance department or qualified person.
3. Open the drain valve to drain the water daily or after every use.When draining, the pressure in the
air tank should be less than 1 bar.
4. Check whether the safety valve is sensitive every week, pull aut the safety valve to check
whether it can be easily exhausted, and it can be reset immediately after pressing it.
5. lt is recommended that remove the filter element of the air filter and clean it with clean high­
pressure air every 200 hours of use, replace the filter element of the air filter every 500 hours of use,
and replace the cylinder and piston ring every 2000 hours of use. The details can be adjusted
according to the actual use.
6. The air tank shall be subjected to a pressure test every two years, and the interna! and external
surfaces shall be inspected once a year. When there is severe rust, severe bruising or failed to pass
the pressure test, the air tank shall be replaced.
7. ln case of severe machine vibration, please pay attention to whether you need to replace the
shock pad.
Precautions for maintenance:
(1)
1) Before disassembling the machine, cut off the power supply, wait for the machine to cool d
and ensure that the air tank is pressure-free.
(2) 2) During the maintenance process, the fasteners should be tightened, if any damage is fou
they should be replaced with new ones.
(3) 3) when the maintenance is over, after re-installation, the fan should be rotated to check
abnormalities
(Note: The left and right fan blow inward when the motor rotates.)