Xterra FS5.5e, Руководство пользователя

Страница: 13 / 27

Xterra FS5.5e / 5.7e Elliptical
12
STEP 4: PLASTIC PARTS ASSEMBLY
1. Mate the Connecting Arm Covers (91 and 92) over the Left Connecting Arm (8) and se-
cure with two M5x15mm Phillips Head Screws (124) and a Ø3.5×12mm Sheet Metal
Screw (125). Tighten the screws using the Short Phillips Head Screw Driver (125). Repeat
for the opposite side.
2. Mate the Swing Arm Covers (87 & 88 on left side and 89 & 90 on the right side). Connect
the halves with three 3.5x12mm Sheet Metal Screws (125) each. Tighten with the Phillips
Head Screw Driver (162).
3. Install Roller Covers (93) onto each set of Rollers. Secure with four M5×15mm Phillips
Head Screws (124). Tighten using the Phillips Head Screw Driver (162).
4. Attach the two covers (L-98) & (R-99) to the middle stabilizer tube. Secure with a
M5×15mm Phillips Head Screw (124) on each side. Secure with the Phillips Head Screw
Driver (162).
5. Attach a “Z” bracket (20) to the rear stabilizer tube on the left and rights sides (with the
hole facing the rear), and secure them with two M6×10mm Phillips Head Screws (164) on
the left and right sides. Secure using the Phillips Head Screw Driver (162).
6. Attach the front Rear Stabilizer Cover (96) to the rear stabilizer tube with two M5×15mm
Phillips Head Screws (124). Secure with the Phillips Head Screw Driver (162). Attach the
back Rear Stabilizer Cover (97) onto the rear stabilizer tube with four M5×15mm Phillips
Head Screws (124). Secure using the Phillips Head Screw Driver (162).
7. Plug in the electrical cord to a properly grounded outlet and turn on the power button,
located at the bottom front of the unit. Raise the incline to Level “8” and attach the Incline
Cover (94) with two M5×15mm Phillips Head Screws (124). Secure using the Phillips
Head Screw Driver (162). Return the Incline to “0”.