6
FS5.8e Elliptical
1. Slide the Incline Rail Assembly (
2
) into the U channel of the Main Frame
(
1
). Be very careful not to damage the wires that exit each part.
2. Connect the Incline Rail Assembly (
2
) horizontally to the U channel of
the Main Frame (
1
) with two Hex Head Bolts (
104
), two Flat Washers
(
137
) and two Nyloc Nuts (
130
). Secure it vertically with four Hex Head
Bolts (
102
), four Split Washers (
151
), four Flat Washers (
142
) and four
Star Washers (
154
). Tighten using the Wrenches provided (
155
&
158
).
3. Connect the Incline Motor wires (
49
&
50
) to the wiring harness that
exits the Incline Rail Assembly (
2
), by matching the colors red, white
and black. Push the excess cable inside the U channel. Guide the twist
tie that is attached to the Computer Cable (
44
) through the bottom of
the Console Mast (
12
) until it exits the top of the steel tube. Secure the
Console Mast (
12
) by loosely threading two Hex Head Bolts (
103
) from
the front and two Curved Washers (
153
) first. Then secure the mast from
the side by loosely threading a Hex Head Bolt (
105
) and a Split Washer
(
152
).
Note
:
There is one bolt already installed in the receiving bracket
that will engage with the slot at the bottom of the Console Mast. Tighten
the two bolts from the left side last.
4. Tighten the two front bolts first, then the side bolts with the Wrench
(
155
).
5. Untie the twist tie from around the Computer Cable (
44
). Plug the
Computer cable (
44
- wide white end) & the two Hand Pulse Cables (
47
)
into the bottom of the Console (
43
). Insert the Resistance Cable (
165
)
into the white port labeled “Load” and the Incline Cable (
166
) into the
Incline port on the back of the Console. Secure the Console (
43
) onto
the mounting plate with four Phillips Head Screws (
116
). Tighten them
with the Phillips Head Screw Driver (
157
).
6. Install the water bottle holder onto the handlebar in any position you like.
FS5.8e
Assembly Instructions
Hardware Step 1
Rear Rail, Console Mast & Console
#102
. 5/16” x 2-1/4”
Hex Head Bolt (4 pcs)
#103
. 3/8” x 3/4”
Hex Head Bolt (2 pcs)
#104
. 3/8” x 1-1/2”
Hex Head Bolt (2 pcs)
#105
. 3/8” x 2-1/4”
Hex Head Bolt (1 pc)
#116
. M5 x 10mm
Phillips Head Screw
(4 pcs)
#130
. 3/8” x 7T
Nyloc Nut (2 pcs)
#137
. 3/8” x 19 x 1.5T
Flat Washer (2 pcs)
#142
. 5/16” x 20 x 1.5T
Flat Washer (4 pcs)
#151
. 5/16” x 1.5T
Split Washer (4 pcs)
#152
. 3/8” x 2T
Split Washer (1 pc)
#153
. 3/8” x 23 x 2T
Curved Washer (2 pcs)
#154
. 5/16”
Star Washer (4 pcs)
1
