24
Customer Service 1-888-707-1880 Dyaco Canada Inc. 2018
Email: [email protected]
ERROR MESSAGES
E0
Safety Key is not in place. A reminder to put in the safety key.
E1
Treadmill calibration did not receive a speed signal for 10 seconds.
E2
Over the rated current. The controller is over the rated current for 3 seconds.
Er
Incline Error.
E4
Motor voltage surge or motor is disconnected.
E5
Communication is disconnected.
E6
Power malfunction.
ENGINEERING MODE
First, remove the Safety key, hold down the Program key and at the same time replace the safety
key. The treadmill’s console will enter Calibration mode.
1. Set wheel diameter to 60. Press the Enter key to confirm and move to the next item.
2. Set kilometers or miles. Press the Enter key to confirm and move to the next item.
3. Set the minimum speed of 0.5. Press the Enter key to confirm and move to the next item.
4. Set the maximum speed of 10. Press the Enter key to confirm and move to the next item.
5. Set the maximum incline value of 10, then press the Enter key to confirm. It will automatically
enter into the calibration display.
6. Press the START/STOP key to start the calibration. It will return to the standby screen
automatically after the calibration is complete.