2.
Hardware Installation
Front Panel
The front panel provides LED’s for device status. Refer to the following table for the meaning of each feature.
Power
The
Power
LED lights up and will keep while the AP is powered on. When the AP goes through its self-
diagnostic mode during every boot-up, this LED will flash. When the diagnostic is complete, the LED will be lit
continuously.
11a
The
11a
LED flashes when there is a successful Wireless-A connection.
11b/g
The
11b/g
LED flashes when there is a successful Wireless-B/G connection.
LAN
The
LAN
LED lights up when Ethernet port of AP was connected to LAN. When the LED is flashing that
indicates the network activity over that port.
Rear Panel
The rear panel features 1 Ethernet port, Reset button and Power port. Refer to the following table for the meaning of each feature.
Power
Ethernet
RESET
RESET Button
The
RESET button
can restore device to factory default settings by press this button for approx. 10 seconds
during device power on status.
LAN
The port connects the AP to your networked PCs and other Ethernet network devices.
Connectors
There are two RPSMA Female connectors,
Ant 1
is for 802.11a and
Ant 2
is for 802.11b/g.
Power
The
POWER
port is where you will connect the power adapter.
WAP-1001 User’s Guide
3
