4. OPERATION GUIDE
4.1.
OPERATION AT POWER UP
The camera employs the default settings the first time it is switched on. Changes to the
settings will be permanently stored and will be made available the next time the camera
is switched on. You can return to the default settings by means of the appropriate menu
option at any time.
The camera will work as follows when it is switched on.
The camera will run a calibration procedure and a message showing the following
information will appear on the video output OSD (On Screen Display): software version,
address, protocol, baud rate and zoom module brand.
Check that the data are suitable for operation. Otherwise, refer to the section in this
document that shows how to install the camera correctly.
MINI DOME II
SOFT VERSION:
5.3
ADDRESS:
1
PROTOCOL:
PELCO
－
D/P
BAUD RATE:
2400
TEMPERATURE
25C
SAMSUNG SERIES CAMERA
At the end of the calibration step, the camera will switch to stand-by as programmed
(
PTZ > POWER UP > ACTION
). The camera will continue working this way until any
command is received from the keypad. The camera during this phase can be pointed to
a fixed point or pan across the field. Refer to the details described in the
POWER UP
menu
section.
4.2.
HOW TO USE OUR CONTROL KEYBOARD
The camera is ready to receive commands from our control keyboard (see figure below)
after connecting.
11 / 56
