XtendLan HomePNA3.0, Руководство пользователя

Страница: 15 / 23

XL-HB14128M HomePNA3.0 Switch User’s Guide
15
Command Sets for Telnet and RS-232 Console
The following table lists all commands for Telnet and RS-232 console. The first column ‘
Location Hierarchy
’ is the
place where the command resides within the directory-like command shell. It is the place where command can be
accepted. An empty field means you can run the command anywhere.
The third column ‘
Description
’ explains what happen when you run the ‘
Commands
’ in the second column. Typing
commands followed by pressing ‘ENTER’ will execute the command.
Either capital letter or lowercase letter can be accepted. Switch responses ‘OK’ message after a successful command,
‘ERROR’ if any mistake. Denote
[ENTER] in the following table for pressing ‘ENTER’ only.
Location
Hierarchy
Commands Description
/ Return to root level ‘ / ’
.. Go up to parent level
save Save current setting permanently (Keep in EEPROM)
default Reset all setting to factory default, except Password
quit Logout and Exit
reboot Reboot switch as power-on state
upsysfw Upgrade switch firmware
uphpnafw Upgrade HomePNA3,0 chip set firmware
password Change your password
/ INFO Enter directory level ‘/INFO’
/ SYSTEM Enter directory level ‘/SYSTEM’
/ PORT Enter directory level ‘/PORT’
/ VLAN Enter directory level ‘/VLAN’
/ QOS Enter directory level ‘/QOS’
/ E1MAC Enter directory level ‘/E1MAC’
/ SNMP Enter directory level ‘/SNMP’
/INFO [ENTER]
Display MAC address, hardware version, firmware version and
HomePNA3.0 chip set firmware version of switch itself. These
parameters are read-only.
/SYSTEM IPADDR= nnn.nnn.nnn.nnn
Set IP address,
n =0~9 (default 192.168.0.1)
/SYSTEM
NETMASK=
nnn.nnn.nnn.nnn
Set subnet mask,
n =0~9 (default 255.255.255.0)
/SYSTEM
GATEWAY=
nnn.nnn.nnn.nnn
Set default gateway for switch,
n =0~9 (default 192.168.0.2)
/SYSTEM IGMP= n
Control switch IGMP snooping function
n =0: Disable IGMP snooping
n =1: Enable IGMP snooping (default)
/SYSTEM TELNETP= n
TELNET port number,
n =0~65535 (default 23)
/SYSTEM WEBP= n
HTTP port number,
n =0~65535 (default 80)
/PORT RCON= n
Control switch rate control function,
n =0: Disable rate control (default)
n =1: Enable rate control
/PORT P x
Enter directory level ‘/PORT/P x ’. For example, ‘/PORT/P1’
represents PORT 1.
x =1~14
/PORT/P x SERVICE= n n =0: Disable HomePNA port x