XtendLan HDC-SDOMEO51MIR-B, Руководство пользователя

Страница: 11 / 23

7
Preparation
This section contains detailed instructions for installing the camera. These instructions assume that
the installer has a good knowledge of installation techniques and is capable of adopting safe
installation methods.
Dip Switch
The factory default is:
Camera Address Protocol Baud Rate
1 Pelco D 9600bps
The camera can detect and auto program its protocol (Pelco D, Pelco P) as well as baud rate
(2400bps, 4800bps, 9600bps, 19200bps) as per the whole video system. In case of VISCA, it
needs to be manually set.
Only the camera address setting is necessary. There are two ways to program camera address:

Soft address: via special preset functions (see Special Control Panel Commands)

DIP Switch: The switches to configure these settings are located on the main board inside the
camera. See Fig.1: DIP Switch.
Fig.1: DIP Switch