XtendLan GSM DPC-G100, Инструкция по установке

Страница: 5 / 8

6) Load the room number and telephone number to call station via PC.
Used for the volume load of room number and telephone number.
6.1)
In ‘Door Guard’ frame select ‘New’ in ‘File’ menu to open the form of phone setting.Select the File→New in PC ,open
the phone setting list.
6.2)
Input the room no. in room item, e.g. 1801. Input phone number in ‘TEL1’, ‘TEL2’, and ‘TEL3’ items. e.g. 83953801,
83953681, and 18923752681. Then click ‘Add’ button to add the room numbers and phone numbers into the phone
setting list. When visitors press 1801 buttons on the call station, then it will call the 3 preset phones successively.
Note : The room number can have 7-
digits figure maximum ‘ ﹡ ’ can be used as the room number, e.g. ‘12 ﹡ 1801’ it
means that as room number 1801 in 12nd buildings. But ‘ ﹡ ’ cannot be used as the 1st digits of one room, e.g. could
not used ‘ ﹡ 1801’ as one room number.
6.3) After inputting all room numbers and phone num
bers, click ‘Refresh’ button to save.
Note : In this form, you can
also modify the room numbers and phone numbers. After modifying, please click ‘Update’
button to update.
6.4)
Select ‘File →Down load file’ and load the data to GSM call station. After loading, it will show ‘DataDownload
Complete’.
6.5) Select
“File→ exit” to exit the program of ‘gsm_door_guard_system’.
6.6) Power off the GSM call station and re-power
it again. After showing ‘Welcome’, it will enter the standby status.
6.7) Back-up the data of phone setting list:To protect to the data of phone setting list, users can back up the 2 files
‘Inhabitant_telnum.mdb’ and ‘user_password.mdb’ into other discs in PC. You can use it immediately if the data is lost.
7) Set room numbers and its corresponding phone numbers via short message
：
Users can add, change or delete the room numbers and its corresponding telephone numbers by sending short
message to the PC .The telephone number must be registered
The format is:*55#system password#room number#serial number#phonenumber
*55# is the warning of room number setting
System password is the code you had set
（
the initial code is 000000
）。
Room number is the number you want to add, change or delete (For example 1801)
Serial number is the sequence of phone number
（
For 2 is the 2nd phone number
）
Phone number is the new number you want to add
For example:“*55#system password#1801#2#83953801”,it means 83953801 is the 2 nd
phone number in room 1801.
Note 1:In above-mentioned info ,if the phone number is 0 ,then it means that it will delete the specific phone
number .For example,*55#system password#1801#2#0,it means that it will delete the 2
nd
telephone number in 1801
Note 2: In above-mentioned info, if the serial number is 0, then it means that it will delete all the phone numbers in that
room. For example,*55#system password #1801#0, it means that it will delete all the phone numbers in room 1801
Note 3: After
receiving the message, the call station will show “New Message” and then show “Welcome” .It means that
the operation is su
ccessful. If still showing “New Message” ,it means message is not received fully .You should wait 30S
until
the call stations show “Welcome” or re-power the call station, then you should re-send the message to call station .